====== Thinkpad on Linux ======
===== Remap keys =====

I am using this to remap keys for faster navigation.
When you pres [Fn] key, the cursor arrows are mapped as follows:

<code>
      [ PGUP ]
[HOME][PGDOWN][END]
</code>

<file ini ~/.Xmodmap>
keycode 171 = End
keycode 172 = Next
keycode 173 = Home
keycode 174 = Prior
</file>

<file bash ~/.xprofile>
#tested on ThinkPad x201
xmodmap -e "keycode 174 = Prior"
xmodmap -e "keycode 172 = Next"
xmodmap -e "keycode 173 = Home"
xmodmap -e "keycode 171 = End"
</file>

===== ThinkFan =====

<file init /etc/modprobe.d/options.conf>
options thinkpad_acpi fan_control=1 fan="level disengaged" beep=6
</file>

Vyvazenej konfigurak, pokud to jde, tak je tichej. Ale pokud to je potreba, tak zacne efektivne chladit s nejmensima rozumnejma otackama. Nemelo by to pri bezny praci delat takovy ty narazy, ze je nejdriv vyplej a pak se zas pusti naplno. Nicmene narozdil od defaultni konfigurace umoznuje pustit vetrak na plny otacky pokud dosahne teplota 90C, takze by se to nemelo prehrejvat jako v defaultu.

<file ini /etc/thinkfan.conf>
(0,     0,      40)
(5,     32,     60)
(6,     59,     70)
(7,     69,     95)
("level disengaged",    90,     32767)
</file>


<code bash>
echo thinkpad_acpi >> /etc/modules
modprobe thinkpad_acpi
systemctl enable thinkfan
systemctl start thinkfan
</code>

===== Modem =====

  * Pro Vodafone stáhnout {{:howto:desktop:gobi_vodafone.tar|tyto oladače}} a rozbalit do adresáře ''%%/lib/firmware/gobi%%''
  * Nainstalovat balicky ''%%apt-get install gobi-loader modemmanager %%''
  * Nepridavat 05c6:9205 (z lsusb) do /usr/lib/udev/rules.d/60-gobi.rules !!! je to USB ID po nahrani FW, pred nahranim to ma 05c6:9204 a to uz tam je. Pokud se tam nahraje i to prvni, tak to dokola loaduje fw a nenabehne to.
  * Restartovat pocitac
  * Po pripojeni skrz networkmanager lze nainstalovat a pouzit program modem-manager-gui k posilani a prijmani SMS, USSD kodu a sledovani detailu pripojeni
==== odkazy a drivery pro ostatni operatory ====

  * http://www.thinkwiki.org/wiki/Qualcomm_Gobi_2000
  * http://support.lenovo.com/us/en/downloads/ds001302

===== Wifi =====

Kdyz zamrzne, jde restartovat takhle (id se muze lisit, viz. lspci). I kdyz vetsinou stejne zamrzne znova:

<code bash>
echo 1 > /sys/bus/pci/devices/0000\:02\:00.0/remove
echo 1 > /sys/bus/pci/rescan
</code>


===== Thinklight =====
Dame vsem prisup k LEDkam:
<code bash /etc/udev/rules.d/10-thinklight.rules>
SUBSYSTEM=="leds", ACTION=="add", RUN+="/bin/chmod -R o=u,g=u /sys%p"
SUBSYSTEM=="leds", ACTION=="change", ENV{TRIGGER}!="none", RUN+="/bin/chmod -R o=u,g=u /sys%p"
</code>

Rebootneme nebo reloadneme ''udevadm control --reload-rules; udevadm trigger --verbose''

Potom vytvorime tenhle skript s pravama pro spusteni:

<code bash /usr/local/bin/thinklight>
#!/bin/sh
led='/sys/class/leds/tpacpi::thinklight/brightness';
state=$(cat "$led");
[ "$state" == 0 ] && new=255 || new=0;
echo "${1:-$new}" > "$led";
</code>

Muzem pouzivat tyhle prikazy
  * ''thinklight'' - vypne/zapne svetylko (idealni jako ikonka na listu)
  * ''thniklight 0'' - vypne
  * ''thniklight 255'' - zapne